Parts/Accessories

Use with AIM Wave Wire SA-133

Copper electrode for single side spot welding. Attaches to SA-109(Quick Spot Handle) Uses Bullet Cap (1 each included) See Part number SA-275 for replacement caps

Single-sided spot welding control gun.   Includes: - Electrode Holder - Switch - 18 inch lead for attachment to HWS - 18 inch control cable with plug to connect with HWS control

Electronic Item; Not-Returnable Charger board with LED's HWS MIG welder 1250

Panel Beater On/Off Rocker Switch

Panel Beater lead cable end to connect a lead to 1/2" inch diameter terminal.  Comes with heat shrink to insulate exposed wire.

Panel Beater lead cable end for connecting lead to 3/8" terminal.  Comes with heat shrink for insulating exposed wire.

Slide Hammer attachment for Panel Beater.  Screws directly into existing PB-200 (Control Handle) and uses PB-104 (Dent Pulling Electrodes). (PB-200 & PB-104 Not Included)

Replacement transformer for the charging system in the 1000DX. (Dent Pullers Manufactured before 2015)   Other configurations available- call 1-800-644-2730

Lead Set for Panel Beater Includes Positive Lead, Negative Lead, Control Cord   *Control Handle NOT Included

Front Wheels found on Panel Beater. Includes two wheels.

Panel Beater Wheels. Includes two wheels and mounting caps.

Activation button switch found for Panel Beater control handle. Includes shrink wrap. Control cord (PB-248) sold separately.

Sculpted black foam grip for Panel Beater control handle and/or puller bar.

15 amp breaker used in the model 1000 DX Charger(PB-211)

Electronic Item-Not-Returnable Charger control board; controls charging and drives charge state indicator lights.  Does not come standard with LED lights (PB-216).

Charger shown is no longer available When ordering this item number a suitable replacement charger will be sent.   When ordering this item you are getting the 10 AMP charger currently installed in the panel beater at the factory. Minor...

Precision tool used for extra leverage.

4" inch diameter magnet